rear_targa_top_seal
REAR TARGA TOP SEAL
When you go to replace the rear targa top seal, which has the fuzzy strip, the original seal will have metal plates cast into the short side pieces. The replacement seal from 914Rubber does not come with those metal plates.
The 2 easiest ways to install the replacement seal are:
1) Cut small strips out of some sheet metal and drill holes in the sheet metal, using the old metal as a template.
2) Remove the original metal strips from the rubber and re-use them on top of the new rubber (drill holes in the new rubber where they needed to line up with the metal and the screw holes - no need to glue anything).
Get the Rear Targa Seal for Porsche 914 here.
rear_targa_top_seal.txt · Last modified: 2022/04/20 19:42 by 914rtkadmin