914Rubber Tribal Knowledge Wiki

REPLACE TRAILING ARM PIVOTS AND WHEEL BEARINGS

Another episode from Ian Karr's restoration of a Porsche 914 LE ”Bumblebee” in his home garage. In this episode (number 15), he replaces the trailing arm pivots and wheel bearings. And while the parts are at the powder coater, he finally installs the dash (restored in episode 4), routes the harness and installs the switches.

Parts used:

Pivot Shaft set from 914Rubber

Rear Trailing Arm Bushing from 914Rubber

Dash Switch Tool from Aircooled